Panasonic KX-P1131E - Manual (Page 29)

High Speed Mode
The High Speed mode is a feature for doubling the print
speed only when LQ Font and one of the 120 dpi,
180 dpi or 360 dpi of 24-pin bit image are selected.
Note
• When enabled, this feature will lower the print
density.
Turning on the High Speed mode:
• While pressing ON LINE , press
LF/FF .
The HIGH SPEED indicator is on.
Turning off the High Speed mode:
• While pressing ON LINE , press
LF/FF .
The HIGH SPEED indicator is off.
Line Feed/Form Feed (LF/FF
Switch)
You can adjust the paper position by using the front
panel switches when the printer is in the OFF LINE
mode or when the printer is not printing in the ON LINE
mode.
• With paper installed, pressing LF/FF once
advances the paper one line.
• With paper installed, holding LF/FF moves
the printhead to the center and advances the
paper to the top of the next page.
Note
• When pressing LF/FF , the amount of paper
which is fed is determined by the current setting
for lines per inch as specified through the
Control Panel Software program, Control Panel
(Initial Setup mode) or your application
software.
Tear Off (TEAR OFF Switch)
Pressing the TEAR OFF switch advances your
fanfold paper’s perforation to the tear position, and
pressing this switch again returns your paper to the first
print line.
Operating Instructions 29
Using the Control Panel