Panasonic KX-P1131E - Manual (Page 30)

Top of Form Function (TOF SET)
This printer has a Top of Form (TOF) function which
stores the first print line position and loads the paper to
the designated position automatically. The first print line
position will be stored even after the power is turned off.
You can adjust the Top of Form position through the
Control Panel Software program (Page 25), or using
Micro Line Feed or Reverse Micro Line Feed from the
Control Panel within 125 mm (5 in.) from the top of your
paper.
Note
• Do not rotate the platen knob, otherwise the
printer will not be able to count the number of
lines properly.
• All adjustments must be made on the first sheet.
If you decide to change the setting and save it,
remove the paper from the tractors, then reset
and reload the paper.
1. If necessary, redefine the page length of the
paper you are using through the Control Panel
Software program (Page 25), Control Panel
(Page 28) or your application software.
2. Micro Line Feed:
While pressing ON LINE , press
TEAR OFF .
This advances the paper one micro line
[0.14 mm (
1 /
180
in.)].
Reverse Micro Line Feed:
While pressing ON LINE , press
LOAD/PARK .
This reverses the paper one micro line [0.14 mm
(
1 /
180
in.)]. The printer cannot reverse the paper
past the printable area (Page 44).
3. At your desired position within 125 mm (5 in.)
from the top of your paper, release the switches.
The paper position will be stored automatically as
the new Top of Form position.
30 Operating Instructions
Using the Control Panel