Patton electronic 1194 - Manual (Page 10)

10
3.0 CONFIGURATION
The Model 1194 has 16 DIP switches that enable configuration of the unit
for a wide variety of applications. This section describes location of the
switches and explains the different configurations.
3.1 CONFIGURING THE HARDWARE DIP SWITCHES
Using a small flat-tip screwdriver, remove the protective cover located on
the underside of the Model 1194 (see Figure 3).
Figure 3. Removing the cover to access DIP switches S1 and S2
Figure 4 shows the orientation of the DIP switches in the “ON” and “OFF”
positions.
Figure 4. DIP switches S1 and S2
511
G.703/G.704 T
est Modes P3
P1 511 E
P4
P2 TM
ERR
P4 P3 P2 P1
P4 P3 P2 P1
G.703/G.704
Fiber
Link
NS
Link
NS
Mod el 1 194 E S ing le Mod e F ibe r - Qua d G .70 3/G .70 4 M ode m
Po we r
511
G.703/G.704 T
est Modes P3
P1 511 E
P4
P2 TM
ERR
P4 P3 P2 P1
P4 P3 P2 P1
G.703/G.704
Fiber
Link
NS
Link
NS
Mod el 1 194 E S ing le Mod e F ibe r - Qua d G .70 3/G .70 4 M ode m
Po we r
1 2 3 4
ON
5 6 7 8
Push toggle up
for ON position
Switch toggle
Push toggle
down for
OFF position
1
2
3
4 ON
5
6
7
8 S1
1 2 3 4
ON
5 6 7 8
S1
S2
1 2 3 4
ON
5 6 7 8
1 2 3 4
ON
5 6 7 8
S1
S2