Panasonic AJ-D455P - Manual (Page 7)

7
q POWER switch
When the ON side is pressed, the power is switched on, and the counter display lights up.
w
Cassette insertion slot
e
EJECT button
When this is pressed, the tape is unloaded and several seconds later the cassette is
automatically ejected. When the counter display indicates “CTL”, the display is reset.
r
EDIT/EDIT REC/REC/REC INH lamps
EDIT:
This lights when the editing mode is chosen from the 9P remote control.
EDIT REC: This lights when editing from the 9P remote control.
REC:
This lights during video recording.
REC INH: This lights when the accidental erasure prevention mode has been set for the
cassette. In this state, neither recording nor editing is possible.
t
REMOTE lamp
This lights when the REMOTE/LOCAL switch has been set to the REMOTE position.
y
WIDE lamp
This lights when the unit is in 16:9 wide screen mode.
u
Tape counter type display
CTL:
This indicates the tape timer (control signal).
TC: This indicates the time code.
UB: This indicates the user bit.
No lighting: The remaining tape is displayed.
i SCH lamp
This lights when the SCH phase of the reference video signal is within the prescribed
range.
o
SERVO lamp
This lights when the drum servo and capstan servo have locked.
!0 Channel condition lamps
One of these lamps lights in accordance with the error rate status. (Green
→
blue
→
red)
Green: This lights when the error rates for the video and audio playback signals are both
acceptable.
Blue: This lights when the error rate for the video or audio playback signals has
deteriorated.
The playback picture will remain normal even when this lamp lights.
Red: This lights when the video or audio signals are subject to rectification or
interpolation.
!1 Level meters
These indicate the PCM audio signal CH1/CH2.
The audio signal indicates the input signal levels during recording and EE selection, and
the output signal levels during playback.
!2
Cassette insertion display lamp
This lights when a cassette has been inserted into the unit.
!3
Counter display
This displays the TC and CTL count values, on-screen information and other messages.