Printek FieldPro RT43 - Manual (Page 32)

Printer Configuration
Using Setup
After the Setup mode is entered, instructions will be printed indicating that the Power Button may be used as a
“Select” button and that the Paper Feed Button may be used as a “Next Menu” button.
As instructed, press the Power to select each menu or item, and press the Paper Feed to skip to the next menu or
item. Upon selecting an Item inside a Menu and pressing Power, the displayed setting will change.
Press Paper Feed to skip to the next item in the menu. When EXIT MENU is displayed, press Power to go to
the next menu.
When in a menu, you may press and hold Paper Feed until it beeps to skip to the next menu.
You may press and hold the Power Button until the printer beeps once to set an item to its default value.
The Interface Menu is the first menu of features displayed. If an optional Bluetooth or Wi-Fi Interface is
installed in the printer, the first option presented will be to switch to the interface that is not currently the active
interface. This feature will typically only be used when needing to switch from the optional interface to Serial
so that the Printek Mobile Setup Utility can be used. After completing any changes with the setup utility, this
same process may be used to switch back to the previously selected interface.
Exiting Setup
To save the changes you have made, press Power when the EXIT SETUP SAVE CHANGES Menu selection
appears.
To exit without saving changes, press Power when the EXIT SETUP DISCARD CHANGES Menu selection
appears, or at any time you may press and hold the Power Button until the printer beeps and turns off.
26