Printek FieldPro RT43 - Manual (Page 9)

Getting Started
Printer Features
Before preparing your new FieldPro RT43 for use, please refer to Figure 1 and familiarize yourself with the
locations of the various features of the printer.
Paper Door
Tear Bar
Paper Door
Release Lever
Battery
Control Panel
Carrying Strap
Power Connector
Universal Port Cover
Right Side
Of Printer
Figure 1 - Printer Features
Battery Installation and Charging
The battery for your FieldPro printer is shipped in an “uncharged” state. The battery must be charged using the
following instructions prior to using the printer for the first time. Maximum battery capacity is not reached
until after completing a minimum of three complete charge and discharge cycles.
Please refer to Figure 2. Install the battery by first placing the end of the battery where the battery contacts are
located into the printer, and then press down on the end where the release lever is located until the lever “snaps”
into place.
3