Multi-unit operation, Operating additional units, Registering a handset to the base unit – Panasonic TG7200-7220E User Manual

Page 30

Advertising
background image

Multi-unit Operation

30

Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333

Operating additional
units

Additional handsets

Up to 6 handsets can be registered to
the base unit.
Important:
L

The additional handset model
recommended for use with this unit is
noted on page 6. If other model
handset is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.

L

Additional handsets will give you the
freedom to, for example, have an
intercom call with another handset
while a third handset is on an outside
call.

Registering a handset
to the base unit

The supplied handset and base unit are
pre-registered. When you purchase an
additional handset, refer to the additional
handset’s installation manual for
registration. If for some reason the
handset is not registered to the base unit
(for example, w flashes even when the
handset is near the base unit), register
the handset.

1

{j

/OK}

2

{^}

/{V}: “Handset Setup” i

{>}

3

{^}

/{V}: “Registration” i {>}

4

{^}

/{V}: “Register H.set” i

{>}

5

Proceed with the operation for your
model.

KX-TG7200/KX-TG7202/

KX-TG7203
Press and hold {x} on the base
unit for about 5 seconds. (No
registration tone)

KX-TG7220/KX-TG7222/

KX-TG7223/KX-TG7224
Press and hold {x} on the base
unit for about 5 seconds, until the
registration tone sounds.

L

If all registered handsets start
ringing, press {x} to stop, then
repeat this step.

L

After pressing {x}, the rest of this
procedure must be completed
within 90 seconds.

6

Wait until “Enter Base PIN” is
displayed. i Enter the base unit
PIN (default: “0000”). i {j/OK}
L

If you forget your PIN, see page
39.

L

When the handset has been
registered successfully, w will
stop flashing. If the key tone is
turned on (page 19), a
confirmation tone will be heard.

Deregistering a handset

A handset can cancel its own
registration (or the registration of
another handset) that is stored in the
base unit. This will allow the base unit to
“forget” the handset.

1

{j

/OK}

2

{^}

/{V}: “Base Unit Setup” i

{>}

3

Enter “335”.

4

{^}

/{V}: “Deregistration” i

{>}

L

The numbers of all handsets
registered to the base unit are
displayed.

TG7200-7220E(e).book Page 30 Tuesday, May 22, 2007 9:34 AM

Advertising