ParaBody 435104 - Manual (Page 7)

FIGURE 7A
(WITHOUT
445104 SECOND
STACK OPTION)
STEP 7A
3/8” LOCK NUT
TOP BOOM
9 3/8” HEX NUT
• SECURELY assemble one 2” PULLEY (5) to the 3/8” THREADED SHAFT on the TOP BOOM using one previously installed 3/8”
WASHER, one 3/8” HEX NUT (9) and one previously installed 3/8” LOCK NUT as shown in FIGURE 7A.
5
3/8” WASHER
FIGURE 6
STEP 6
• SECURELY assemble the previously removed 4-1/2” PULLEY to the BASE using one 3/8 X 2-1/4” BOLT (14), two previously
removed 3/8” WASHERS, one previously removed 2-7/8” L-BRACKET, one SWIVEL SNAP (6), one 3/8” HEX NUT (9), and one
previously removed 3/8” LOCK NUT. See FIGURE 6.
BASE
14 3/8 X 2-1/4”
3/8” WASHER
4-1/2” PULLEY
2-7/8” L-BRACKET
6
9 HEX NUT
3/8” LOCK NUT
• If the 445104 SECOND STACK OPTION is installed follow STEP 7B .
3/8” WASHER
• Remove one 3/8” WASHER and one 3/8” LOCK NUT from the 3/8” THREADED SHAFT on the TOP BOOM.
7