Initial set up, N auto mode – Pioneer VSX-39TX User Manual

Page 38

Advertising
background image

38

3 Using the remote control display,

follow the instructions below to
adjust the speaker levels so that you
hear the test tone at the same
volume from each speaker when
seated in your normal listening
position.

NOTE : The volume of the subwoofer tends to sound
lower than it actually is. You may need to adjust the
level after testing with an actual soundtrack.

I

n AUTO mode

1 Use the +/– (or

5˜∞) buttons to adjust the level of

the speaker outputting the test tone. The tone will
automatically switch between speakers after
sounding for 2-3 seconds.

2 Adjust the level of all speakers.

In MANUAL mode

1 Use the +/– (or

5˜∞) buttons to adjust the level of

the first (the front left) speaker.

2 Press the button on the touch panel for the next

speaker.

3 Repeat 1 and 2 for each speaker.

If you are using a Sound Pressure Level (SPL)
meter
Take the readings from your main listening position
and adjust the level of each speaker to 75 dB SPL (C-
weighted/slow mode).

You can use the

5˜∞ buttons at the bottom of

the remote control instead of the +/– buttons.

4 When all the speaker levels have

been set, press SETUP OK to return
to the SYSTEM SETUP MENU.

The display on the receiver will say RESUME and the
MASTER VOLUME will return to its original position.

dB

STEREO

SIGNAL

SELECT

ANALOG SP

A

AUTO

VOLUME

Next, proceed to CROSSOVER NETWORK below.

Note that it is also possible to set channel levels
temporarily. Then follow the same procedure as
explained on this page. This function is designed to be
used when you want to change the levels temporarily
to raise the level of one channel. Using this method you
can set speaker levels in different modes, such as,
STEREO, and each DSP mode, independently. You
should return the settings to their original state when
done. Doing the set up procedures on this page will
erase any temporary/independent level settings that
have been made.

initial Set Up

memo

memo

3

4

5˜∞ buttons

ENTER

DVD/LD

TV/SAT

VCR1

VCR2

STANDBY/ON

BACK LIGHT

on/off

AUTO

T.TONE

MANUAL

T.TONE

AUTO

T.TONE

MANUAL

T.TONE

Advertising