Panasonic SC-HT500 - Manual (Page 10)

10
RQT6835
Si
mple se
tu
p
[Note]
The wall or pillar on which the speakers are to be attached should
be capable of supporting 10 k
g per screw.
1
[For\the\United\Kingdom]and]Continental\Europe]
Remove the stand before attaching
the front and center speakers.
BEFORE REMOVING THE STAND
≥ Take the speaker cable out of the stand’s hole if it is
threaded through.
≥ Lay the speaker on a soft cloth.
Unscrew the screw with a Phillips-head screwdriver.
2
Screw a screw (not included) into the
wall.
3
Fit the speaker securely onto the
screw with the hole or holes.
Preparation
Remove the stand (
➡ step 1 above).
Ensure the stands meet these conditions before purchasing them.
≥ Observe the diameter and length of the screws and the distance
between screws as shown in the diagram.
≥ The stands must be able to support over 10 k g .
≥ The stands must be stable even if the speakers are in a high
position.
Notes on speaker use
≥ You can damage your speakers and shorten their useful life if you
play sound at high levels over extended periods.
≥ Reduce the volume in the following cases to avoid damage.
–When playing distorted sound.
–When the speakers are receiving howling from a record player,
noise from FM broadcasts, or continuous signals from an
oscillator, test disc, or electronic instrument.
–When adjusting the sound quality.
–When turning the unit on or off.
If irregular coloring occurs on your television
These speakers are designed to be used close to a television, but
the picture may be affected with some televisions and set-up
combinations.
If this occurs, turn the television off for about 30 minutes.
The television’s demagnetizing function should correct the
problem. If it persists, move the speakers further away from the
television.
Other speaker setup options
Attaching to a wall
Stand
30–35 mm
Wall
‰ 7.5–9.4 mm
8–11 mm
Vertical Horizontal
100 mm
Fitting speaker stands (optional)
5 mm
pitch 0.8 mm
60 mm
Caution
≥ Use the speakers only with the recommended system.
Failure to do so may lead to damage to the amplifier
and/or the speakers, and may result in the risk of fire.
Consult a qualified service person if damage has
occurred or if you experience a sudden change in
performance.
≥ Do not attempt to attach these speakers to walls using
methods other than those described in this manual.