Philips CSM1000 - Manual (Page 6)

7
Connect wires
Caution
Ensure that all loose leads are insulated with •
electrical tape.
1
Connect the subwoofer to your car audio
by:
(option 1) connect to bare speaker •
wires from car audio.
(option 2) connect to the car audio
•
directly via an RCA cable.
3 Installation
Note
Follow all mounting and wiring instructions. •
Mount the subwoofer in car
You can mount the subwoofer either under a
seat or on the rear tray.
Note
Make sure that the mounting location is safe •
for drilling and wiring, and it will not interfere
with the mechanical and electrical components
of the vehicle.
For under-seat installation, make sure that it
•
does not obstruct seat mobility.
1
Place the subwoofer on the location for
installation.
2
Mark the positions of the four screw
holes.
3
Drill the holes with driller of
approximately 4mm in diameter.
4
Mount the subwoofer with the supplied
screws and brackets.
English
EN