Philips SDR-S50 - Manual (Page 28)

28
VQT2L35
Preparation
Setup
6
Setting date and time
When the unit is turned on for the first time, a message asking you to set the date and time
will appear.
Select [YES] and perform steps 2 to 3 below to set the date and time.
¬ Change the mode to .
1
Select the menu. (l 23)
2
Select the date or time, then
adjust the desired value with
the joystick.
A Displaying the World time setting
(l 29):
[HOME]/ [DESTINATION]
≥ The year can be set between 2000 and
2039.
≥ The 24-hour system is used to display the
time.
3
Press the joystick to enter the
selection.
≥ The clock function starts at [00] seconds.
≥ A message may be displayed prompting
you to set the world time. (l 29)
≥ Press the MENU button to complete the
setting.
Changing the date and time display
mode
Select the menu. (l 23)
[SETUP]
# [DATE/TIME] # [OFF]/[D/T]/
[DATE]
Changing the date format
Select the menu. (l 23)
[SETUP]
# [DATE FORMAT] # [Y/M/D]/
[M/D/Y]/[D/M/Y]
≥ The date and time function is driven by a
built-in lithium battery.
≥ When this unit is purchased, the clock is
set. If the time display becomes [- -], the
built-in lithium battery needs to be
charged. To recharge the built-in lithium
battery, connect the AC adaptor or attach
the battery to this unit. Leave the unit as it
is for approx. 24 hours and the battery will
maintain the date and time for approx.
6 months. (The battery is still being
recharged even if the power is off.)
[SETUP] # [CLOCK SET]
WARNING
THE LITHIUM BATTERY IN THIS UNIT
MUST ONLY BE REPLACED BY
QUALIFIED PERSONNEL. IF THIS IS
NECESSARY, CONTACT THE PANASONIC
CUSTOMER CARE CENTRE ON 132600
FOR YOUR NEAREST AUTHORIZED
SERVICE CENTRE.
SDRS50&H85GN-VQT2L35_mst.book 28 ページ ２００９年１２月２９日 火曜日 午前１０時３０分