Printronix T5000e Series - Manual (Page 22)

Chapter 1 Installation
22
Figure 8. Position the Ferrite
13. On the electronics side of the printer, position the ferrite on top
of the upper DC motor. (Figure 8.)
14. Route the power/data cable through the wire saddle, then
under the power supply cable as shown in Figure 8.
15. Plug the power/data cable into the J10 receptacle on the
controller board.
16. Install the expansion-CT subassembly, if you removed it in
step 3, page 17.
J10
Power/Data Cable
Ferrite
Upper
DC Motor
Power Supply Cable
Wire Saddle