Printronix T5000e Series - Manual (Page 62)

Chapter 2 Bar Code Failures
62
• You can set the number of bar codes generated by a
bitmapped image that the printer should expect per form by
selecting a value in the “Number of Codes” parameter.
For more information on choosing a value for the “Number of
Codes” parameter, see “Setting Number Of Bar Codes On A Form”
on page 48.
Error Action
Whether the error stems from a bad or missing bar code, the printer
response is the same. The printer response is determined by the
“Validator Action” setting in the VALIDATOR menu:
1. Press to take the printer offline and place the printer in
Menu mode.
2. If necessary, press
↓ and ↵ at the same time to unlock the
↵ key.
3. If necessary, press until “VALIDATOR” displays.
4. Press
↓ until “Validator Action” displays.
5. Press + or – to scroll through the choices:
• Stop
• Overstrike
• Retry Form (default)
These options are described in detail below.
6. Press
↵ to select the desired value.
7. Press ↓ and ↵ at the same time to lock the ↵ key, then press
PAUSE to take the printer offline.
8. Press PAUSE again to put the printer online.
Stop
If the system detects a bar code failure, the print job stops, the
printer status indicator lamp flashes, the alarm sounds, and the
appropriate error message displays.
..
.
..
.