Precor ELECTRONIC CONSOLE 903 - Manual (Page 14)

page 14
5. Remove the paper backing from one side of the thin
pad and press the pad firmly in place onto the
flywheel. See Diagram 11.
6. To mount the magnet and reed switch continue with
the steps below,
Attaching the Magnet and Reed
Switch.
Attaching the Magnet and Reed
Switch
For the electronic console displays to operate properly, a
magnet and reed switch need to be precisely installed. The
magnet is mounted to the flywheel and the reed switch is
placed on the side rail. Mounting pads indicate where you
need to mount the hardware. Be sure to follow the previous
instructions
Installing the Mounting Pads before attaching
the magnet or reed switch.
To install the magnet and reed switch, take the following
steps:
CAUTION: To ensure the integrity of the reed switch,
lower the handrails before mounting the reed switch.
Allowing excess wire near the flywheel eliminates the
possibility that the reed switch will be pulled out of
position. If you are not sure how to lower the handrails,
refer to your Owner’s Manual.
Diagram 11