Precor ELECTRONIC CONSOLE 903 User Manual
Page 9
Advertising
page 9
904 Assembly Procedures
To install the 904 electronic console, take the following
steps:
1.
Remove the handrail clamp from its box. Take the long
and short screws out of the handrail clamp using your
fingers or a Phillips head screwdriver. Set the screws
aside.
2.
Position the handrail clamp over the right handrail’s
micro-adjustment knob as shown in Diagram 6. Place
a hand on either side of the handrail clamp to gently
pull it apart so that you can slide it onto the handrail’s
foam grip and into position (about 8 inches above the
base of the foam grip).
Important: Do not mount the clamp on the painted
surface of the handrails.
Diagram 6
Advertising