Panasonic KX-TGA520C - Manual (Page 3)

– 3 –
Registration
This cordless handset must be registered to a KX-TG5200C/KX-TG5202C/KX-TG5230C/
KX-TG5240C/KX-FPG391C base unit. The handset will be assigned the extension number
at registration. Only one handset can be registered at a time. Charge the battery fully.
Make sure the base unit and the other handsets are not being used. Have both the
handset and base unit nearby during registration.
• Base unit model shown here is KX-TG5240C.
* The location of the LOCATOR button varies by base unit model.
KX-TG5200C/KX-TG5202C: LOCATOR [ ], [ ], [ ], [ ] or [
]
KX-TG5230C/KX-TG5240C/KX-FPG391C: [LOCATOR/INTERCOM/TRANSFER]
The handset display shows the instructions as shown on the
right.
• The registered number “[1]” to “[4]” is shown on the top right of the display.
• You can stop registration by pressing [OFF] on the handset and pressing the *LOCATOR
button on the base unit.
• If you try to register this handset to the KX-TG6500C base unit, “Wrong handset
Refer to manual” is displayed. The base units for this handset are mentioned above.
1 Base unit: Press and hold the *LOCATOR button for 3 seconds.
• The CHARGE indicator flashes. After the CHARGE indicator starts flashing, the rest of
the procedure must be completed within 1 minute.
• On the KX-FPG391C, “HS REGISTRATION” is displayed.
2 Handset:
(1) Press the soft key (
).
(2) Wait until a long beep sounds and the display
shows the new extension number.
• Registration is complete.
To cancel the handset registration, please see your base unit Operating Instructions.
OK OK BACK BACK
CHARGE Indicator
*LOCATOR Button
To operate “ ”,
press the right soft key.
OK
1
Press LOCATOR
on base unit
for 3 sec.
Then press OK
[-]
L
Press LOCATOR
on base unit
for 3 sec.
Then press OK L
BACK FRANÇ. O K
OK
SPIPRIVACY 1
Handset
Registering
IN USE [-]
SPIPRIVACY 1
Handset [2]
Registered
IN USE [2]
e.g. Extension number 2
TGA520CE.fm Page 3 Monday, April 5, 2004 6:15 PM