POLAR CS300 - Manual (Page 7)

6
2. INSTALL
2.1 INSTALL BIKE MOUNT
Use cable ties to secure the bike mount snugly on the
handlebar as shown above.
To ensure the most accurate reading, attach the wrist unit
to the bike mount every time you do a cycling exercise.
2.2 INSTALL SPEED SENSOR
1. Attach the speed sensor on the opposite side of the front fork than the mounted cycling computer. The
distance from the cycling computer should be 30-40 cm/1’-1’3’’. If you are exercising in surroundings with
electromagnetic interference, the distance should be minimized (minimum 30 cm/1’). The speed sensor and
cycling computer should form approximately a 90° angle.
If the distance between the cycling computer and the speed sensor should be longer than recommended (for
example with mountain bikes with the front suspension), the speed sensor should be attached on the same side
of the front fork as the cycling computer. In this case the maximum distance is 50 cm/1´6”.
2. Attach the rubber part to the sensor.
2.
max 50 cm / 1’6’’
1.