Patton electronic 1082/F - Manual (Page 12)

12
3.0 CONFIGURATION
The Model 1082/F is equipped with 8 DIP switches that enable configu-
ration of the unit for a variety of applications. This section describes
switch locations and explains the different configurations.
3.1 CONFIGURING THE HARDWARE DIP SWITCHES
Using a small flat-tip screwdriver, remove the protective cover located on
the underside of the Model 1082 (see Figure 4).
Figure 4. Removing the cover to access DIP switches S1 and S2
TM
ER
NS
LOS
NetLink 64K/G.703 iDSL
Modem
G.703
DSL
Link
Status
Test Modes
51 1/RDL Normal
51 1E
Remote
Normal
Local