Pride Mobility Jazzy 100 - Manual (Page 25)

Jazzy 100 www.pridemobility.com 25
To change the armrest width:
1. Locate the two armrest knobs on each side of the armrest re-
ceiver bracket. See figure 23.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Tighten the knobs.
Armrest Height Adjustment
To change the armrest height:
1. Loosen the two setscrews located on the armrest receiver. See
figure 23.
2. Raise or lower the armrest to the desired height.
3. Tighten the setscrews to secure the armrest.
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the floor.
2. Loosen the jam nut. See figure 23.
3. Turn the adjustment screw to raise the front of the armrest or to
lower the front of the armrest.
4. Tighten the jam nut to lock the adjustment screw into place.
Controller Position
You can move the controller in toward or out away from the armrest, or
change the position the controller for either left-hand or right-hand use.
WARNING! Do not place the controller cable so
that it can be pinched in the seat frame or the
power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See figure 24.
3. Slide the controller into or out of the armrest to the desired position.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the power base.
3. Cut any wire ties that attach the controller cable to the armrest.
4. Flip up the armrests and loosen the setscrews. See figure 24.
5. Slide the controller out of the armrest and place it in the other armrest.
6. Tighten the setscrews on the bottom of each armrest.
7. Use a wire tie to secure the controller cable to the armrest.
8. Plug the controller connector into the power base.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several different heights.
To raise or lower the foot platform:
1. Remove the mounting hardware from the foot platform. See
figure 25.
SETSCREW
Figure 25. Foot Platform Height Adjustment
Figure 26. Foot Platform Angle Adjustment
Figure 24. Underside of Armrest
V I . C O M F O R T A D J U S T M E N T S
MOUNTING HARDWARE
SETSCREW