Pride Mobility Jazzy 100 User Manual

Page 39

Advertising
background image

Jazzy 100

www.pridemobility.com

39

I X . C A R E A N D M A I N T E N A N C E

Battery Replacement

A battery wiring diagram is printed on a decal located on the battery well frame. Refer to the specifications table for correct
battery specifications.

WARNING! The batteries on your power chair should only be serviced or replaced by an authorized

Pride Provider or a qualified technician.

WARNING! Do not replace the battery when the seat is occupied.

WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds.

Wear goggles and gloves when handling batteries and wash hands after handling.

WARNING! Power chair batteries are heavy. See specifications table. If you are unable to lift that

much weight, be sure to get help.

WARNING! Do not mix or match new and old batteries. If you encounter a situation where one

battery needs to be replaced, then replace both batteries. Refer to specification table in this

manual and the manual supplied with the battery charger for recommended type and capacities.

Figure 32. Drive Wheel

REAR RIM
HALF

TUBE

TIRE

FRONT
RIM HALF

NUTS

WHEEL HUB

Figure 33. Drive Wheel Disassembled

WASHERS

4. Remove the drive wheel nut and washer from the axle. See figure 32.
5. Pull the wheel off the axle.
6. Remove the nuts and washers from the wheel hub and separate the front and rear rim. See figure 33.
7. Remove the old tube from the pneumatic tire and replace it with a new tube or replace the entire assembly if it is a solid

tire.

8. Reassemble the rims and reinstall the nuts and washers to the wheel hub.
9. Slide the wheel back onto the axle. Make sure the key is in the axle slot.
10. Reinstall the drive wheel nut and washer onto the axle and tighten.
11. Inflate the pneumatic tire to 35 psi (2.4 bar).
12. Remove the power chair from the blocks.

Follow these easy steps for a quick and safe repair for both pneumatic and solid tires:
1. Turn off the power to the controller.
2. Set the power chair up on blocks.
3. If you are changing a pneumatic tire, completely deflate it before removing the wheel.

DRIVE WHEEL NUT

DRIVE WHEEL
WASHER

AXLE SLOT

AXLE KEY

Advertising