Panasonic SC-PM10 - Manual (Page 9)

RQT6682
9
Before use
A Setting the time
by remote control only
This is a 24-hour clock.
The example shows how to set the clock for 18:30 (6:30 pm).
1
Press [y y y y y] to turn the unit on.
2
Press [CLOCK / TIMER] to display “CLOCK”.
Every time you press the button:
CLOCK PLAY
Original display
REC
3
Within 10 seconds
Press [g, REW/ 4 4 4 4 4] or [f, 3 3 3 3 3/FF] to set the
time.
Press and hold to change the time faster.
4
Press [CLOCK / TIMER].
The time is set and the original display is restored.
To switch to clock display (For Europe: only in CD/tape
mode)
Press [DISPLAY].
Each time you press the button:
Clock display
↔ Current display
To show the time (when the unit is ON)
Press [CLOCK / TIMER].
The clock is shown for about 10 seconds.
Note
The clock may lose or gain some time over a period.
Readjust if necessary.
B Convenient Functions
by remote control only
To dim the display panel
Use this when you are going to sleep or any other time you
would prefer the panel to be dimmer.
Press [DIMMER].
The display panel dims except for the [AC IN] indicator.
To cancel
Press [DIMMER] again.
To mute the volume
This feature is convenient when you have a telephone call,
etc.
Press [MUTING].
“MUTING” appears.
To cancel
Press [MUTING] again. (“MUTING” goes out.)
Muting can also be cancelled by lowering the volume all the
way to (-- dB).
When the system is turned off, the muting operation will be
automatically cancelled.
C Turning the demo function off
If the clock has not been set, a demonstration of the display
is shown when the unit is switched to standby.
This function is set to on at the time of purchase.
Press and hold [–DEMO] until “DEMO OFF” is
displayed.
The display changes each time the button is held down.
DEMO OFF (off)
↔ DEMO ON (on)
MUTING
RQT6682(2-10)new 1/11/03, 2:27 PM 9