Troubleshooting, Cont’d) – Philips DVDR615 User Manual
Page 68
68
English
3139 246 14221
Troubleshooting
(cont’d)
The index screen flickers
when a DVD+R is inserted.
Picture is fuzzy and
brightness varies when
copying DVD Video discs or
prerecorded video
cassettes.
The message ‘NO SIGNAL’
appears.
The message 'Recording of
<XX> will start within 1
minute' appears.
The message 'Insert
recordable disc' appears.
The message 'Maximum
number of timers reached'
appears.
The message 'Collision'
appears.
– You can finalize the disc using the following function:
1) Press OPEN/CLOSE on the DVD recorder to open the disc
tray.
2) Insert the disc but do not close the tray.
3) Hold down button number {4} on the remote control until the
tray closes. ‘FINALIZING' appears on the display panel.
4) If finalizing has been successful, the Picture Index screen will
appear.
– This happens if you try to copy DVDs or video cassettes that
have been copy-protected. Even though the picture on the TV is
fine, but the recording on a DVD+R(W) is faulty. This
interference is unavoidable with copy-protected DVDs or video
cassettes.
– The DVD+R(W) has recording lifetime, please change a new disc
for recording.
– Check that the cable is plugged in firmly.
– If a recording is made from a video recorder, change the tracking
on the video recorder.
– The DVD recorder may not be able to recognize the video input
signal if this signal is poor or does not comply with relevant
standards.
–
Select { Switch now } to switch the DVD recorder to standby
mode. A programmed timer recording will only start recording if
the DVD recorder is in standby mode.
–
Select { Suspend } will suspend the timer recording.
–
Select { Cancel recording } will cancel the timer recording.
–
Either no disc was inserted or a disc was inserted that cannot
be used for recordings. Insert a disc that can be recorded upon.
Locate on the disc the right position for the recording. Press
STOP button. Turn off the DVD recorder by pressing
STANDBY-ON button.
–
It has reached the maximum programmed, no more recordings
are allowed. Press TIMER button, select the programmed
recording (TIMER block) you want to check or clear using 3 4
button.
–
The timer recording overlaps with another timer recording.
–
If you ignore this warning, the programmed recording with the
early start time will start first.
The second recording will then lack the beginning.
–
Change the information for one of the two recordings.
–
Delete one of the two recordings.
Problem
Solution
DVDR610_615_37_Engfinal434
8/16/04, 4:12 PM
68