Panasonic DMC-FX01 - Manual (Page 83)

Connecting to other equipment
83
VQT0V86
1 Turn on the camera and the
printer.
2 Connect the camera to a printer
via the USB connection cable A
(supplied).
• Connect the USB connection cable with
the [ ] mark facing the [ 2] mark on
the [DIGITAL] socket.
• Hold the USB connection cable at C
and insert straight in or take straight
out.
3 Press 4 to select [PictBridge
(PTP)] and then press [MENU/
SET].
• If you set [USB MODE] in the [SETUP]
menu to [PictBridge (PTP)] in advance,
it is not necessary to set this every time
you connect to a PC. (P20)
• Do not use any other USB connection
cables except the supplied one.
• To print the age in [BABY1]/[BABY2]
(P51) in scene mode or the departure
date for [TRAVEL DATE] (P54), use the
software [LUMIX Simple Viewer] in the
CD-ROM (supplied) and print from the
PC. For information about this, refer to the
separate operating instructions for PC
connection.
• To find out more about PictBridge
compliant printers, contact your local
dealer.
∫ Single picture
1 Press 3 to select
[SINGLE PICTURE] and then
press
[MENU/SET].
2 Press 2 1 to select the picture
and then press 4.
• The message disappears in about
2 seconds.
3 Press 3 to select [PRINT START]
and then press [MENU/SET].
• Press [MENU/SET] to cancel printing.
4 Disconnect the USB connection
cable after printing.
USB MODE
SELECT SET MENU
PictBridge(PTP)
PC
PLEASE SELECT
THE USB MODE.
/SET
MENU
SELECT SET
DPOF PICTURE
SINGLE PICTURE
PictBridge
MENU /SET
MENU
PLEASE SELECT
THE PICTURE TO PRINT
PictBridge
1 / 3
100_0001
EXIT
SELECT
PRINT
MENU
OFF
SINGLE PICTURE
NUM. OF PRINTS 1
PRINT WITH DATE
PAPER SIZE
PAGE LAYOUT
SELECT CANCEL SET MENU
PRINT START
/SET
MENU
VQT0V86ENG.book 83 ページ ２００６年１月３０日 月曜日 午前９時４６分