Pride Mobility Microdrive Controller INFMANU2581 - Manual (Page 14)

14 Basic Operation Instructions
Microdrive Controller www.pridemobility.com
NOTE: When a toggle switch is set to “J/S,” the joystick has control of a
particular function. When the toggle switch is set to “Local,” control of
this function is disabled at the joystick.
External Switch Jacks
The external switch jacks are used for an external control (e.g., buddy button,
single switch, etc.). There are two external jacks on the joystick interface module:
mode and power. The switches can work in conjunction with or in replacement of
switches on the joystick.
Horn Toggle
The horn toggle disables the horn key on the controller.
Speed Toggle
The speed toggle disables the speed adjustment dial on the controller.
Mode Toggle
The mode toggle disables the mode switch on the controller.
Power Toggle
The power toggle disables the on/off switch on the controller.
Redel Connector Port
The redel connector port is used for the power module interface.
Off-board Charger/Programming Socket
The off-board charger/programming socket is used for off-board charger con-
nection and controller programming. If you use an off-board charger, the charger
current should not exceed 8 amps. Contact your authorized Pride Provider for
more information.
WARNING! Only chargers with Neutrik NC3MX plugs should
be connected to the off-board charger/programming socket.
See your authorized Pride Provider for more information.
Failure to heed can result in personal injury and/or product
damage.