Panasonic SC-HT65 - Manual (Page 4)

4
RQTV0225
Standby indicator [^]
When the unit is connected to the AC mains supply, this
indicator lights up in standby mode and goes out when the
unit is turned on.
Standby/on switch [8]
Press to switch the unit from on to standby mode or vice
versa. In standby mode, the unit is still consuming a small
amount of power.
Main unit
Display
[-MENU, ―SETUP, RETURN]
For entering menus to make various settings.
For returning to previous menus. •
•
[TUNE, 3, 4]
For tuning the radio and selecting menu or setup items.
SETUP MIC jack
For calibration microphone
[kHz, MHz]
Frequency unit indicators
kHz: AM, or PCM sampling frequency
MHz: FM
[TUNED, ST, MONO]
Radio indicators
TUNED: A station is tuned
ST: A stereo FM broadcast is tuned
MONO: You have switched to monaural mode to improve
reception
[SLEEP]
Sleep timer indicator.
[PCM, C.FOCUS]
PCM: Lights when the PCMFIX mode is set
C.FOCUS: Appears when you are using Center Focus
[ENTER]
Used during menu or setup operations.
[RDS, PS, PTY]
Shows the current RDS display mode.
[SFC, 2CH MIX]
SFC: Appears when you are using an SFC mode
2CH MIX: Appears when you are listening to a multi-channel
source with headphones
[VOLUME]
Volume control.
[ ] Headphone jack
Plug type: 3.5 mm stereo
Sound does not come from the speakers if you connect
headphones.
Avoid listening for prolonged periods of time to prevent
hearing damage. •
•
General display
Shows the input mode, radio frequency and other general
information.
[DIGITAL INPUT]
Lights when input is digital.
INPUT SELECTOR TUNE MENU
RETURN
SETUP
SETUP MIC
VOLUME
ENTER
AUTO
SPEAKER SETUP
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
7
8
9
Remote control signal sensor
1
2
3
4
5
6
[% DIGITAL, DTS, % PL ΙΙ]
Lights to indicate the source's input signal and decoding
format used.
%
DIGITAL: Dolby Digital sources
DTS: DTS sources
%
PL ΙΙ: Dolby Pro LogicΙΙ decoder is being used
7
8
[M]
Flashes or lights during presetting. 9
[INPUT SELECTOR, <, >]
For selecting input.
10
10
AUTO SPEAKER SETUP
Flashes during Auto Speaker Setup. Lights when the setup
finishes.
10
Control guide
[W]
Lights when you are using the digital transceiver (
➡ page 7).
Flashes when there is no link between the main unit and the
wireless system
(For details, refer to the operating instructions for SH-FX65).
11
TUNED MONO SLEEP PTY PS RDS PCM ST
kHz
MHz
DIGITAL DTS
PL 2CH MIX
SFC
M
C.FOCUS
DIGITAL INPUT W
1
2
3
4
5
6
7
9
11
8
10
Control guide
SC-HT65 GN-En.indb 4 8/17/2007 4:19:48 PM