PYLE Audio SLV5400 User Manual
User manual
Advertising
Table of contents
Document Outline
- User Manual
- Contents
- Overview
- Control and display elements
- 1 On/off switch
- 2 Power light:
- 3 RECORD SOURCE button
- 4 Link source indication lights
- 5 TV1 SOURCE button
- 6 AUTO light
- 7 Integrated remote control blaster light
- 8 TV1 source indication display
- 9 Antenna
- 10 scart ports:
- 11 Wireless channel selection switch
- 12 Power input connector (DC 12V)
- 13 AUDIO OUT connectors (red/white)
- 14 SCART port for TV1
- 15 Remote control blaster cord port
- 16 On/off switch
- 17 Power light
- 18 Source selector buttons (+/-)
- 19 Integrated remote control blaster light
- 20 Antenna
- 21 Wireless channel selection switch
- 22 SCART port for TV2
- 23 Power input connector (DC 12V)
- 24 Connector
- 25 Blaster light
- Control and display elements
- Your Wireless TV Link
- Safety
- Installation
- 1 Switch off the transmitter (A).
- 2 Connect the remote control blaster cord (G) to the IR port.
- 3 Position the blaster light in front of the video source.
- 4 Switch on the transmitter (A).
- 5 Take the remote control of a video source with you.
- 6 Go to TV2.
- 7 Switch on TV2.
- 8 Switch on the receiver (B).
- 9 Select the correct SCART input on TV2.
- 10 Operate the video source with its remote control .
- 11 If necessary, repeat the steps 3 to 10 for the other video sources.
- Installation
- Installation
- Operation
- Enjoy your Wireless TV Link
- Operation
- 7 Press + or - on the receiver (B) to select the VCR or DVD recorder; or: press 4 on the remote control (C).
- 8 Select the channel on the VCR or DVD recorder with its remote control.
- 1 Switch on the transmitter (A).
- 2 Switch on TV1.
- 3 Select the correct SCART input on TV1.
- 4 Select the video source with TV1 SOURCE; or: press + or - on the remote control (C).
- 5 Switch on the video source.
- 6 Operate the video source with its remote control.
- Operation
- Use additional features
- 1 Select a video source with SELECT.
- 2 Select the correct SCART input on the VCR or DVD recorder.
- 3 Push RECORD on the VCR or DVD recorder.
- 4 Push PLAY on the video source.
- 1 Take an audio cable (red and white plugs).
- 2 Plug the connectors of one end into the AUDIO OUT connectors on the transmitter (A).
- 3 Plug the connectors of the other end into the AUDIO IN connectors of your amplifier.
- Use additional features
- Troubleshooting
- Troubleshooting
- Information