Setting the clock 1 2 3 4, Setting dvd menu options – Philips MCD 908 User Manual
Page 3
Setting the clock
1
2
3
4
In standby mode, press and hold
CLOCK
on the remote.
When the hour digits flash, turn
VOLUME-/+
on the system or press
VOLUME+/-
on the
remote to set the hours.
Press
CLOCK
again and the minute digits flash. Then turn
VOLUME-/+
on the system or
press
VOLUME+/-
on the remote to set the minutes.
Press
CLOCK
again to confirm the time setting.
Setting DVD menu options
IMPORTANT!
If the progressive scan feature is activated but the connected TV does not support
progressive signals or the cables are not connected accordingly, see the user
manual for proper progressive scan setup or deactivate the progressive scan
feature as below:
1) Turn off your TV progressive scan mode or turn on to interlaced mode.
2) Press SYSTEM on the remote to exit the system menu and then DISC and “1”
to exit progressive scan.
Tip
See chapters "Getting Started" and "System Menu Options" in the
User Manual for detailed descriptions.
CODE
SPDIF SETUP
COMPONENT
QUALITY
HDMI SETUP
MCD908 QUG_Eng-98
2006.10.23, 16:48
3