Pride Mobility 1170XL Plus 2VHD - Manual (Page 17)

Jazzy 1170 XL Plus Series www.pridemobility.com 17
MOTOR/BRAKE ASSEMBLY
I I I . Y O U R P O W E R C H A I R
Figure 6. Jazzy 1170XL Plus Series Power Base (Shroud Removed)
ELECTRONICS TRAY
FREEWHEEL LEVER
BATTERIES
FREEWHEEL LEVER
Electronics Tray
The electronics tray is located on the back of the power base. See figure 6. The main circuit breaker and controller
connectors are located on the electronics tray.
Main Circuit Breaker: The main circuit breaker is a safety feature built into your power chair. When the batteries
and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage
to the motors and the electronics. If the circuit trips, allow your power chair to “rest” for approximately one
minute. Next, push in the circuit breaker button, turn on the controller, and continue normal operation. If the main
circuit breaker continues to trip repeatedly, contact your authorized Pride Provider.
Controller Connector: This is where the controller connects to the power base. Each controller uses a different
type of harness. Regardless of which type of controller is used, the harness must be secured to the seat assembly
and not allowed to drag on the floor.