Pride Mobility 1170XL Plus 2VHD - Manual (Page 26)

26 www.pridemobility.com Jazzy 1170 XL Plus Series
V . C O M F O R T A D J U S T M E N T S
Figure 16. Anti-tip Bracket (Inner Locknut) Figure 17. Anti-tip Wheel Adjustment (Cam)
Positioning Belt
Your power chair may be equipped with a positioning belt
that can be adjusted for operator comfort. See figure 18.
The positioning belt is designed to support the operator so
that he/she does not slide down or forward in the seat. The
positioning belt is not designed for use as a restraining
device.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat hinge to
the seat base on both the left and right seat hinges.
2. Insert the screw through the supplied washer, through
the positioning belt and into the seat base for each side
of the power chair seat.
3. Tighten both screws.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the belt into the plastic housing on the opposite side until you
hear a click. See figure 18.
2. Pull the excess strap attached to the metal tab until it is secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning belt is properly secured to the power chair and is
adjusted for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose or damaged parts before each use of the
power chair. If you discover a problem, contact your Quantum Rehab Provider for maintenance
and repair.
Figure 18. Positioning Belt Adjustment