Maintenance, Engine oil – Polaris IQ Turbo Dragon User Manual
Page 99
96
MAINTENANCE
Engine Oil
Oil Change
18. Remove the oil filter cap, then remove the oil filter. Inspect the o-
ring and replace it if it's worn or damaged.
19. Install a new filter, then reinstall the cap. Tighten the cap to 18.5 ft.
lbs. (25 Nm).
20. Remove the jumper from the starter motor wiring harness. Recon-
nect the solenoid and the originally-installed harness. Reinstall the
20A EFI Fuse.
21. Remove the dipstick from the oil tank. Add 2 quarts (1.9 liters) of
the recommended oil. Reinstall the dipstick.
22. Start the engine and allow it to idle for 3-5 minutes. Make sure the
engine coolant temperature is between 145 and 160 degrees F. (63-
71 degrees C).
23. Stop the engine.
24. Remove the dipstick from the oil tank. Clean the dipstick with a
clean shop towel and reinstall it, screwing it in completely.
25. Remove the dipstick and view the oil level.
Safe operating range
Fill mark for oil changes
(at specified coolant temperature)
- Turbo LX 2009 IQ Turbo Dragon 2009 IQ Turbo Switchback 2012 Turbo IQ 2012 Turbo IQ LXT IQ Turbo LX IQ Turbo Switchback FST IQ Touring FST IQ Cruiser FST IQ LX 2011 Turbo IQ 2011 Turbo IQ LX 2011 Turbo IQ LXT 2015 600 IQ LXT 2014 Turbo IQ LXT 2011 600 IQ LXT 600 IQ Touring 2010 FST IQ Touring FS IQ TOURING 7427 C 2011 600 RMK 144 2011 600 RMK 144 ES 2011 600 RMK 155 2011 600 RMK 155 ES 600 RMK Shift 700 RMK 155 800 RMK 155 800 RMK Shift 700 Dragon RMK 700 RMK 800 Assault RMK 600 RMK 144/155 800 Dragon RMK 155/163 600 RMK 155 Pantone 425C 800 Dragon RMK 163 800 RMK 144/155 600 HO RMK 155 600 HO RNK 144 2013 Turbo IQ LXT 2012 600 IQ LXT INTL 2013 600 IQ LXT 2010 WideTrak IQ 2009 WideTrak IQ 2012 FS IQ WideTrak 2011 Widetrak IQ 2013 FS IQ WideTrak 2013 600 IQ WideTrak 600 IQ Widetrak 600 Widetrak IQ 2012 600 WideTrak IQ 2014 600 IQ LXT