Panasonic DMC-FZ10PP - Manual (Page 40)

Recording pictures (basic)
40
ª Adjusting flash output
Adjust the flash output when the subject
is small or reflection ratio is extremely
high or low.
1 Press 3 until [ FLASH]
appears on the screen to set the
flash output.
• You can adjust this from j2 EV to
i2 EV in steps of 1/3 EV.
• The determined flash output is
memorized even if the camera is
turned off.
¬Suggestions/Tips ¬
• In Night portrait mode [ ], flash
setting is fixed to Slow sync./Red-eye
reduction [
].
• In Motion image mode [ ] or when
the flash is closed, flash setting is fixed
to the Forced OFF [
].
• When using the flash in ISO AUTO
setting, the ISO sensitivity is
automatically adjusted from ISO50 to
ISO400. To avoid noises, decrease the
ISO sensitivity.
• Do not stare at the photo flash from
close proximity when using the
flash.
• If you bring the flash too close to
the subjects, they may be distorted
or discolored by its heat and
lighting.
• Do not cover the photo flash with
your fingers or any other items.
• If the subject is too close when using
the flash, the picture may be over
exposed.
• When the jitter alert appears, we
recommend using the flash.
• When you set to burst mode or auto
bracket, only 1 picture is recorded for
every flash activated.
• The flash icon turns red when
activating the flash and pressing the
shutter button halfway.
• When the flash is being charged, the
flash icon blinks red, and you cannot
take a picture even when you press
the shutter button fully.
• When taking a picture with the
flash, we recommend removing the
lens hood. In some cases it may not
allow the scene to be illuminated
properly.
• When taking a picture with the flash,
the white balance will be automatically
adjusted [except for [
] (Daylight)
and [ ] (Flash)], but the white
balance may not be properly adjusted
when the photo flash is insufficient.
• When the shutter speed is fast, the
flash effect may not be sufficient.
• To avoid noises, we recommend
setting each item on [PICT.ADJ.] to
[LOW]. (P79)
• Refer to P74 for the ISO sensitivity.
• Refer to P84 for the external flash.
FLASH
SET
WB
REVIEW
SET
WB
REVIEW
SET
WB
REVIEW
EXIT SELECT
WB
FZ10-PP.book 40 ページ ２００３年１１月１８日 火曜日 午後１時７分