Philips HTS3400 - Manual (Page 12)

12
English
Connections
1
3
2
AUDIO IN
R L
VIDEO
IN
TO TV INT IN
CH3 CH4
ANT IN
2
1
RF coaxial cable to TV
IMPORTANT!
If S-Video is used for DVD playback
connection, the system’s VIDEO
OUT setting will need to be changed
accordingly.
Using S-Video jack
1
Use an S-video cable (not supplied) to
connect the DVD system’s S-VIDEO
OUT jack to the S-Video input jack
(or labeled as Y / C or S-VHS) on the TV.
2
To hear the TV channels through this
DVD system, use the supplied audio
cables (white / red) to connect AUDIO
IN-TV) jacks to the corresponding
AUDIO OUT jacks on the TV.
IMPORTANT!
If your TV only has a single Antenna In
jack (labeled as 75 ohm or RF In), you
will need an RF modulator in order to
view DVD playback on the TV. See
your electronics retailer or contact
Philips for details on RF modulator
availability and operations.
Using an accessory RF modulator
1
Use the supplied composite video cable
(yellow) to connect the DVD system’s
VIDEO OUT jack to the video input
jack on the RF modulator.
2
Use an RF coaxial cable (not supplied) to
connect ANTENNA OUT or TO TV jack
on the RF modulator to the ANTENNA
IN jack on the TV.
3
Connect the Antenna or Cable TV
service signal to the ANTENNA IN or
RF IN jack on the RF modulator. (It may
have been connected to your TV
previously. Disconnect it from the TV.)
Option 3 Option 4
Back of RF Modulator
(example only)
Antenna or
Cable TV signal