Plinius Audio Plinius 9100 User Manual
Page 8
8
TAPE OUTPUTS
TAPE OUTPUTS
TAPE OUTPUTS
TAPE OUTPUTS
These RCA outputs are situated next to the tape RCA inputs, and are provided to interface to a pair of line
level recording devices. The position of the record selector on the front panel determines from which
device a recording is being made. As these tape outputs are always ‘live’, both can be used to record the
chosen signal at any time.
MUTE S
MUTE S
MUTE S
MUTE SWITCH
WITCH
WITCH
WITCH
The mute switch enables disconnection of the output, without the need to use the remote control. When
the amplifier is in mute, the LED on the front panel will dim.
GROUN
GROUN
GROUN
GROUND LIFT SWITCH
D LIFT SWITCH
D LIFT SWITCH
D LIFT SWITCH
This switch allows the signal ground to be disconnected from the chassis. In some installations a hum
loop may exist due to duplicate ground paths from different equipment. Use this switch to remove the
connection from 0V to ground thus allowing some flexibility in your particular set-up.
PR
PR
PR
PRE OUT OUTPUT
E OUT OUTPUT
E OUT OUTPUT
E OUT OUTPUT
The Pre-Out connection is provided to enable the Plinius 9100 to be connected to an external power
amplifier. The signal from this output is line level, and as such is not amplified by the power stage of the
Plinius 9100.
MAINS PO
MAINS PO
MAINS PO
MAINS POWER CORD IEC SOCKET
WER CORD IEC SOCKET
WER CORD IEC SOCKET
WER CORD IEC SOCKET
This connector is where the mains supply cable from your wall connects to the amplifier. You will notice
that a fuse holder is mounted within this connection, and it holds a mains fuse to provide surge and
overload protection for your amplifier.
RRRRAIL FUSES
AIL FUSES
AIL FUSES
AIL FUSES
These tubular fuse holders house the positive and negative rail protection fuses. Depress and turn anti-
clockwise to open. An LED is fitted next to each fuse holder to indicate a blown fuse.