Philips 700 - Manual (Page 10)

3 When you have stored the excess cord, guide the mains cord
through the small groove in the rear of the grey charger base.
4 To reattach the charger cover, press it down over the charger base
until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel charger and
use it without the charger cover and charger base.
Cleaning
Do not clean brush heads, the handle, the charger or the charger covers
in the dishwasher.
toothbrush handle
1 Remove the brush head and rinse the metal shaft area with warm
water.
Do not push on the rubber seal on the metal shaft with sharp objects,
as this may cause damage.
2 Wipe the entire surface of the handle with a damp cloth.
Brush head
1 Rinse the brush head and bristles after each use.
2 Remove the brush head from the handle and rinse the brush head
connection at least once a week with warm water.
Charger
1 Unplug the charger before you clean it.
2 Wipe the surface of the charger with a damp cloth.
storage
- If you are not going to use the appliance for a long time, unplug it, clean
it and store it in a cool and dry place away from direct sunlight. You can
use the cord wrap facility (specific types only) to store the mains cord
in an organised way.
- You can store brush heads on the pegs at the back of the charger.
EnglisH
10