Philips 700 - Manual (Page 8)

Brushing modes
The Sonicare automatically starts in the default Clean mode. To select a
different brushing mode:
1 Press the on/off button to toggle between modes.
, The green LED indicates the selected mode.
Note: You can only switch between modes when the toothbrush is switched on.
Clean mode
Standard mode for superior teeth cleaning.
Sensitive mode (specific types only)
Gentle yet thorough cleaning for sensitive gums and teeth.
Clean and White mode
2 minutes of Clean mode with an additional 30 seconds of White mode to
focus on the visible front teeth.
Note: When the Sonicare is used in clinical studies, the default 2-minute Clean
mode must be selected. However, in whitening/stain reduction studies, the
Clean and White mode must be selected. The handle should be fully charged
and the Easy-start feature deactivated.
Features
Easy-start
- This Sonicare comes with the Easy-start feature activated.
- The Easy-start feature gently increases power over the first
14 brushings to help you get used to brushing with the Sonicare.
Note: Each of the first 14 brushings must last at least 1 minute to move
through the Easy-start ramp-up cycle properly.
Note: When the Clean and White mode is selected, the Easy-start feature is
inactive.
deactivating or activating the Easy-start feature
1 Attach the brush head to the handle.
2 Place the handle in the plugged-in charger.
- To deactivate Easy-start:
Press and hold the on/off button for 2 seconds. You hear 1 beep to indicate
that the Easy-start feature has been deactivated.
- To activate Easy-start:
Press and hold the on/off button for 2 seconds. You hear 2 beeps to
indicate that the Easy-start feature has been activated.
Note: Use of the Easy-start feature beyond the initial ramp-up period is not
recommended and reduces the effectiveness of the Sonicare toothbrush in
removing plaque.
EnglisH
8