Paradyne COMSPHERE 6700-A2-GB22-00 - Manual (Page 41)

Custom Network Interface Settings
5-7 Issue 1 September 1994
Choosing Port Settings
Use Port... to specify communications port settings for SLIP,
CSLIP, or PPP interfaces.
!
CAUTION:
Perform changes to port settings other than baud rate and
connector settings with caution. Hardware flow control is the
default setting due to binary communication requirements.
.
Procedure
1. Choose Settings... from the Network menu. The
Custom window appears, as shown in Figure 5-1.
2. Choose Setup from the Custom window menu bar.
3. Choose Port... from the Setup menu. The Port
Settings dialog box appears, as shown in Figure 5-5.
Table 5-3 describes the fields on the Port Settings
dialog box.
Figure 5-5. Port Settings Dialog Box