PSB Speakers 6919217 - Manual (Page 14)

Bare Wire Connection Banana Plug Connection Spade Plug Connection
Loosen 1/2" (13mm)
wingnut. Insert wire
through hole and tighten
nut. Takes wire sizes up
to 8 gauge. Insert banana plug into
the top of the wingnut.
Ensure the wingnuts are
tightened. Loosen wingnut to expose
the top of the jumper strap.
A 1/4"(6mm) or 5/16"(8mm)
spade will fit on the
narrower section of the
post. Tighten the wingnut.
marked with ‘+’ plus signs, or one wire under the insulation may be
different from the other.) Use this wire coding, together with amp/receiver
and speaker colour-coding, to be sure you are connecting the same wire
of a given pair to a like-coded terminal at both ends of your connection.
Assure all wiring terminals are tightened firmly but be careful not to over
tighten and damage the connectors.
Bi-Wiring or Bi-Amping Options
PSB Synchrony speakers can be bi-wired (separate cables to the
separated woofers and midrange/tweeters from the same amplifier
(except on the Synchrony S Surround)) or bi-amped (separate
amplifiers). With single cable inputs, the jumper straps must be in place
and both sets of terminals tightened firmly. Before bi-wiring or bi-amping,
ALWAYS remove the metal jumper straps that connect the two sets of
binding posts on the speaker. Loosen ½” (13mm) wingnuts to remove the
jumper strap.With bi-amp hookup you must use either identical amplifiers
or amplifiers adjusted to have the same voltage gain. Consult your PSB
dealer or our Web site for further information.
14
O
w
n
e
r’
s
M
a
n
u
a
l