PSB Speakers 6919217 - Manual (Page 6)

Adjusting Rubber Levelers
and Spikes
(Tower Speakers)
Attach the supplied spikes or rubber
levelers to the bottom of the speaker
as shown in the diagram at right. On
carpets, position the speakers and
adjust spikes to the desired height
(higher for thicker carpet) and hand
tighten the locknuts against the bottom
of the cabinet.
Adjusting Rubber Foot
(For Center Channel Models)
The Synchrony One C and Two C
center channel speakers come supplied
with a multi-position foot that allows
them to be placed at a variety of
angles.
Notice that the foot has a long edge and a
short edge. Either surface may be
attached to the system depending on the
angle of tilt required. An adhesive strip is
provided to permanently attach the foot to
the cabinet.
When placed below your viewing screen
you can tilt the system upwards by placing
the foot under the front edge of the
system. To aim the system straight
outward, place the foot under the rear
edge with the longer side in contact with
the system. It will be raised by the shorter
dimension. If the system is well above
your viewing screen and a downward tilt is
required, then attach the shorter
dimension to the back of the cabinet. This
will give the maximum rise for the greatest
downward tilt.
Apply the provided felt discs to the corners
of the opposite edge (front or back) to
prevent marring your system or equipment
cabinet.
6
O
w
n
e
r’
s
M
a
n
u
a
l