Philips HTS3105 - Manual (Page 40)

40
English
Tuner Operations
IMPORTANT!
Make sure the FM and MW
antennas are connected.
Tuning to radio stations
A Press SOURCE repeatedly until “FM”
appears on the display panel (or press
TUNER on the remote control).
B Press S / T briefl y on the remote
control to start tuning.
“SEARCH > or <” will appear on the
display panel until a radio station with
suffi cient signal strength is found.
C Repeat step B if necessary until you fi nd
the desired radio station.
D To fi ne-tune the reception of a weak
station, press W / X briefl y and
repeatedly until optimal reception is
found.
Presetting radio stations
You can store up to 40 FM and 20 MW
preset radio stations in the memory.
There are three different ways to
programme the radio stations:
– Using auto install (for fi rst time setup
only)
– Using
automatic preset
– Using manual preset
Helpful Hints:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no stereo signal is detected or less than
5 (fi ve) stations are detected during tuner
installation, “PLEASE CHECK ANTENNA”
appears.
Using auto install
This feature is only applicable for fi rst
time radio station programming. You will
be prompted to install the radio stations
when you access the tuner mode. With
one touch of button, all the available
radio stations will be stored
automatically.
A Press TUNER.
“AUTO INSTALL PRESS PLAY”
appears.
B Press PLAY X until “START ...” appears
on the display panel.
The system will start searching from
the FM band followed by the MW band.
All the available radio stations with
strong signal will be stored automatically.
Once complete, the last tuned radio
station will be played back.
display panel