Panasonic WV-CF254 - Manual (Page 17)

-15-
1. Camera Identification (CAMERA ID)
Setting
You can use the camera identification (CAMERA
ID) to assign a name to the camera. The camera ID
consists of up to 16 alphanumeric characters. You
can select whether to have the camera ID dis-
played on the monitor screen or not.
To edit the CAMERA ID
1. Move the cursor to the CAMERA ID parameter.
2. Press
(S). The CAMERA ID menu appears.
The cursor on the letter “0” starts blinking.
3. Move the cursor to the character you want to
change by pressing (L)/ (R)/ (U)/
(D).
4. After selecting the character, press (S).
The selected character appears in the editing
area. (The pointer in the editing area moves to
the right automatically at this moment.)
5. Repeat the steps above until all characters are
edited.
To enter a blank space in the CAMERA ID
Move the cursor to SPACE and press (S).
To edit a specific character in the CAMERA ID
1. Move the cursor to the editing area by press-
ing (S).
2. Move the pointer to the character to be edited
by pressing (L) or (R). Then move the
cursor to the character area and select a new
character.
3. Press (S) to determine the CAMERA ID.
Character Cursor
Pointer
Character
Area
Command
Editing
Area
CAMERA ID menu
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SYNC INT
WHITE BAL ATW
END SET UP ENABLE
↵
↵
↵
0123456789
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
().,'":;&#!?=
+-*/%$
SPACE
POSI RET END RESET
................
SETTING PROCEDURES
To erase all characters in the editing area
Move the cursor to RESET and press (S). All
characters in the editing area disappear.
To determine the display position of the
CAMERA ID
1. Move the cursor to POSI, and press (S).
The display shown below appears and the
CAMERA ID starts blinking.
Blinking
2. Move the CAMERA ID to the desired position
by pressing (L)/ (R)/ (U)/ (D).
3. Press (S) to fix the position of the CAMERA
ID. The mode returns to the previous CAMERA
ID menu.
Notes:
• The CAMERA ID stops at the edges of the
monitor screen.
• The CAMERA ID moves faster if any of
(L)/ (R)/ (U)/ (D) is kept
pressed for a second or longer.
To return to the CAM SETUP menu
Move the cursor to RET and press (S). The
CAM SETUP menu appears.
2. Light Control Setting (ALC/ELC)
You can select one of the following light control
modes:
ALC: This camera has an ALC lens..
ELC: If you select this mode, the iris is kept open.
Select a SHUTTER parameter to control the
brightness.
1. Move the cursor to the ALC/ELC parameter.
2. Select ALC or ELC.
WV-CF254
** CAM SET UP **
CAMERA ID OFF
ALC/ELC ALC
SHUTTER ---
AGC ON
SYNC INT
WHITE BAL ATW
END SET UP ENABLE
↵
↵
↵