Panasonic SC-AK340 - Manual (Page 12)

12
RQT8043
RQTV0066
LANG - 5
LANG - 4
FRANÇAIS
DANSK
ESP
AÑOL
By remote control only
record
specifi c
discs/tracks 1) Press [DISC] and then [1] ~ [5] to select
the disc.
Ensure disc is stopped.
2) Press [PLAY MODE] to select the desired
mode ( \ page 7).
3)
For 1-ALBUM mode and 1-SONG mode:
Press [ALBUM ( or )] to select the
album.
For 1-SONG mode:
Press [ 4, REW / ] or [¢, / FF] to
select the track.
Tape-to-tape recording:
➀ Press [ 3, TAPE] and then [7, STOP].
➁ Press [ 0 OPEN] for DECK 1 and insert the cassette
to record.
3 Press [ ¶, REC] to start recording.
Other basic operations Other basic operations
To Action
stop recording Press [ 7, STOP].
record on the other
side of the tape Turn the cassette over and press [ ¶, REC].
erase a recorded
sound 1) Press [ 3, TAPE] and then [7, STOP].
2) Insert the recorded tape into DECK 2.
Ensure there is no tape in DECK 1.
3) Press [ ¶, REC].
Your attention is drawn to the fact that recording pre-
recorded tapes or discs or other published or broadcast
material may infringe copyright laws.
Note:
• Changes to volume and sound adjustments do not affect
recording.
• You cannot open DECK 1 while recording.
• You cannot fast-forward or rewind one deck while recording with
the other.
Erasure prevention Erasure prevention
The illustration shows how to remove the tabs to prevent
recording. To record on the tape again, cover as shown.
Side A
Tab for side A Tab for side B
To re-record
Normal cassette
Adhesive tape
Numeric
buttons
Recording Recording
Selection of tapes for recording
Use normal position tapes.
High position and metal position tapes can be used, but this
unit will not be able to record or erase them correctly.
Preparation
Wind up the leader tape so recording can begin
immediately.
1 Press [OPEN 0] for DECK 2 and insert the cassette
to be recorded.
Insert with the side to be recorded facing towards you
and the exposed tape facing down.
2 Select the source to be recorded.
Radio recording:
Tune in the station. (
\ page 13)
Disc recording:
➀ Insert the disc(s) you want to record.
Press [ 6, CD] and then [7, STOP].
➁ Prepare the desired disc recording mode.
To Action
record
programmed
tracks
Perform steps 2 to 4 in “Program play”
(
\ page 8).
Perform steps 3 to 6 in “Program play”
(
\ page 8).
Cassette tape – Play and record (Continued)
RQTV0066-B.indd 12 RQTV0066-B.indd 12 11/16/05 9:37:20 AM 11/16/05 9:37:20 AM