ParaBody 893103 - Manual (Page 7)

7
• Pull back the SPRING PIN and slide the SAFETY RAILS (9) over the UPRIGHTS (5) until the SPRING PIN is engaged in the
first hole.
FIGURE 6
STEP 6:
1
9
9
5
3
• Slide the CARRIAGE (3) over the UPRIGHT FRAME (1) as shown in FIGURE 6.
• Route end of CABLE (25) (WITHOUT BALL) through the TOP BOOM (2) as shown in FIGURE 7.
FIGURE 7
STEP 7:
• SECURELY assemble two 3-1/2” PULLEYS (23) to the TOP BOOM (2) using two 3/8 X 2-3/4” BOLTS (28), four 3/8”
FLANGE SPACERS (42), and two 3/8” LOCKNUTS (36). See FIGURE 7. (NOTE: BEFORE TIGHTENING, MAKE SURE
THE CABLE (25) IS IN THE GROOVE OF THE PULLEYS.)
36
42 44
2
3/8 X 2-3/4” 28
42
23
• Insert one 3 X 2” END CAP (44) into the TOP BOOM (2) as shown in FIGURE 7.
25
5