Panasonic DMR-E95H - Manual (Page 50)

50
RQT7392
Con
v
e
n
ie
n
t func
tions
Channel/Clock settings when TV Guide On Screen TM system is not used
Refer to the control reference on page 47.
Preparation:
If the television program list has already been downloaded, return the unit to the factory preset condition using the steps indicated below.
When the unit is on and stopped
1 Press and hold [ X CH] and [ W CH] on the main unit for about five seconds.
The unit turns off.
2 Press [ Í DVD POWER] to turn the unit on.
3 Complete the TV Guide On Screen TM system setup (until [ENTER] is pressed after the “Watch
TV” message screen is displayed).
[Note]
You can set timer recording only manually after you set the unit with “Auto Channel Setting”.
1
Press [SETUP].
2
Press [ 3 , 4 ] to select “Channel” and
press [ 1 ].
3
Press [ 3 , 4 ] to select “Auto Channel
Setting” and press [ENTER].
4
Press [ 2 , 1 ] to select “Yes” and
press [ENTER].
5
Press [ENTER].
Auto Channel Setting starts. This takes a few minutes.
The unit then proceeds with Auto Clock Setting. The time is
displayed when finished.
≥ DST, Daylight Saving Time, shows the summertime setting.
≥ TIME ZONE shows the time difference from Greenwich
meantime (GMT).
EST (Eastern Standard Time) l GMT j 5
CST (Central Standard Time) l GMT j 6
MST (Mountain Standard Time) l GMT j 7
PST (Pacific Standard Time) l GMT j 8
AST (Alaska Standard Time) l GMT j 9
HST (Hawaii Standard Time) l GMT j 10
For other areas: xx hr
≥ If the Auto Clock Setting does not start automatically, select
“Auto Clock Setting” from the “Set Up” tab.
≥ If the time was not set correctly, use manual clock setting
( ➡ page 11) or time zone adjust.
6
Press [ENTER].
≥ The unit configures channels according to the Antenna
System settings as follows.
Adjust the time zone ( j 1 or i 1) if it was not set correctly with auto
clock setting.
You cannot change this setting if you set the clock manually.
1
Press [SETUP].
2
Press [ 3 , 4 ] to select “Set Up” and
press [ 1 ].
3
Press [ 3 , 4 ] to select “Time Zone
Adjust” and press [ENTER].
4
Press [ 3 , 4 ] to select “ s 1” or “ r 1”
and press [ENTER].
To exit the screen
Press [SETUP].
To return to the previous screen
Press [RETURN].
REC
TIME SLIP SD PC DVD HDD
OPEN/CLOSE
DRIVE SELECT
CH TIME SLIP
/x1.3
X CH W
Auto channel/clock settings
SETUP
Disc
Video
Audio
Auto Clock Setting
Auto Clock Setting is complete.
4/4/2002 12:15 AM
DST............. ON
TIME ZONE.... CST
Channel
Set Up
Antenna system Band Channel
TV
VHF 2–13
UHF 14–69
CATV
VHF 2–13
CATV LOW BAND 95–99
CATV MID/SUPER BAND 14–36
CATV HYPER BAND 37–65
ULTRA BAND
66–94
100–125
SPECIAL CATV CHANNEL 1
Time Zone Adjust
SETUP
Disc
Video
Set Up
Time Zone Adjust
j 1
0
i 1
Channel
7392en.book 50 ページ ２００４年４月２７日 火曜日 午後５時３０分