Philips LX7500R/04 - Manual (Page 48)

w Features
1 Press and hold DVD/MON for 1 second.
2 Press SYSTEM MENU.
3 Press
1 as often as necessary to select A.
4 Press
4 or 3 as often as necessary to select w Features.
Next, press 2 to confirm.
5 Press
4, 3 as often as necessary to select the desired
function. Next, press
2 to confirm.
6 Press
4, 3 as often as necessary to select the desired
setting.You can choose as follows:
Status box
With OSD (On Screen Display) not only screen menus,
but also information on the current operating status
(counter, playback, recording TV channel…) are displayed
on the TV screen.You can switch off the OSD information
to avoid recording it when recording from the
DVD recorder system to additional equipment.
➜ On:The OSD information appears in every selected
mode for a few seconds and disappears again.
➜ Off:The OSD information is switched off and is no
longer displayed on the TV screen.
Standby
You can switch off the clock display on the DVD recorder
system to save power. Programmed recordings will
nevertheless be executed.
➜ Low power: If the DVD recorder system is switched to
standby by pressing 2, the clock display is
switched off.
➜ Normal: If the DVD recorder system is switched to
standby by pressing 2, the clock display is still
visible.
➜ Demo mode: A list with the most important features
scrolls on the display when the DVD
recorder system is switched to standby.
Display
Select a level for the display brightness.
Note: You cannot switch off the display completely.
7 Press OK to confirm the new setting.
8 Press
1 to end.
x Remote control settings
You can set the remote control type to which your
DVD recorder system should respond to: DVD player,
DVD recorder.
1 Press and hold DVD/MON for 1 second.
2 Press SYSTEM MENU.
3 Press
1 as often as necessary to select A.
4 Press 4 or 3 as often as necessary to select x Remote
control settings. Next, press
2 to confirm.
5 Press
4, 3 as often as necessary to select the remote
control type to which your DVD recorder system should
respond to:
➜ DVD player:The DVD recorder system responds
additionally to a DVD player remote
control (remote control code RC-6).
Choose this setting if the remote control
of your Philips TV set supports DVD
functions.
➜ DVD recorder:The DVD recorder system responds
only to the supplied remote control.
6 Press OK to confirm the new setting.
7 Press
1 to end.
System settings
48
English
A B C D E F G
2 17 off off no off
t
u
w
x
Remote control settings
Remote control used DVD player
A B C D E F G
2 17 off off no off
t
u
w
x
Features
Status box On
Standby Normal
Display Bright