Time code and user’ s bit, Time code, User’ s bit – Panasonic AJ-D230HP User Manual
Page 19: Time code and user’s bit, User’s bit
Time Code and User’s Bit
Time code
The time code signal generated by the time code generator is recorded on the tape as a time
code, it is read out by the time code (signal) reader, and used to display the absolute position of
the tape in increments of hours, minutes, seconds and frames.
The time code is written in the sub-code area (data area) of the helical track. For this reason, it
can be read out across a wide range of VTR playback speeds from the stop mode to slow
playback and to high-speed playback.
The time code is indicated by the display or by the figures superimposed onto the screen.
TCR 00 : 07 : 04 : 24
Hours Minutes Seconds Frames
User’s bit
The user’s bit is a 32-bit (8-digit) information frame contained in the time code signals which is
made available to the user. It enables the operator number and other information to be
recorded.
The figures 0 to 9 and the letters ABCDEF can be used for this bit.
19