Connect the speaker cables, Drive a screw into the wall, Fit the speaker(s) securely onto the screw(s) – Panasonic SC-HTB351 User Manual
Page 13
Getting started
RQT9670
13
Connect the speaker cables.
≥ Insert the wire fully, taking care not to insert beyond the wire insulation.
Drive a screw into the wall.
≥ Use the measurements indicated below to identify the screwing positions on the wall.
≥ Leave at least 20 mm (
25
/
32
q) of space above and on each side of the speaker to allow enough space for fitting the
speaker.
≥ The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 kg
(72.8 lbs).
≥ Keep the screws out of reach of children to prevent swallowing.
Fit the speaker(s) securely onto the screw(s).
≥ Place the speaker that is connected with the speaker cable with a red connector on the observers’ right, and connect with
the speaker cable with a white connector on the observers’ left.
1 Insert the wire fully.
r: White
s: Blue line
2 Press into the groove.
A At least 30 mm (1
3
/
16
q)
B
‰4.0 mm (
5
/
32
q)
C
‰7.0 mm to ‰9.4 mm
(
9
/
32
q to
3
/
8
q)
D Wall or pillar
E 5.5 mm to 6.5 mm
(
7
/
32
q to
1
/
4
q)
F Front speaker
(Rear view)
G 102 mm (4
1
/
32
q)
H 37 mm (1
15
/
32
q)
I Wall mounting
hole
J WHITE: Left speaker channel (L)
K RED: Right speaker channel (R)
DO
DO NOT
≥ Move the speaker so that the screw is in this
position.
≥ In this position, the speaker will likely fall if moved to
the left or right.
Push
Red
White
SC-HTB351_RQT9670_mst.book Page 13 Thursday, December 29, 2011 1:39 PM