Precor Commercial Stretch Trainer C240 - Manual (Page 5)

page 5
®
Diagram 2
StretchTrainer parts.
Unpacking the StretchTrainer
The StretchTrainer comes equipped with everything
you need to assemble it. Refer to Diagram 2. It is
shipped in the following pieces:
z Seat assembly (padded seat, knee pad,
bolts and washers)
z base rails (2)
z handlebar (includes wrist straps)
z instructional placard
• assembly kit
3mm and 6mm hex keys
Two E-rings
Two foot rests
Two rear level adjustors (for the base rails)
Seat bumper
Axle
Alignment bracket
Several fasteners (bolts, washers, and nuts)
z literature kit - not shown in Diagram 2 (includes
the assembly instructions and warranty card)
Carefully unpack the pieces and lay them on the
floor near the location where you plan to use it. If
any items are missing, contact the dealer from whom
you purchased the StretchTrainer or use the Precor
web site at www.precor.com to find the dealer
nearest you.
Assembly Instructions
To assist you in the assembly of the StretchTrainer,
refer to Diagram 2 while performing the following
steps.
Important: Assemble and operate the StretchTrainer
on a solid, level surface. Also, have rags or paper
towels available to set the fasteners on during
assembly. Be aware that the lubrication on the
fasteners can stain carpeting and clothing.
Extra tools needed: A small crescent (or open-end)
wrench and needle-nose pliers.
1. Ask for assistance in assembling the
StretchTrainer. Putting the seat assembly
together and positioning it and the handlebars
over the base rails is a difficult procedure for
one person. Fully assembled, the StretchTrainer
weighs over 60 pounds.
2. Set the base rails on the floor. Ask for an
assistant to hold the upright supports together
while you align and secure the base rails.
Wrist
straps
Upright
support
Knee pad
Padded seat
Base rails
Foot rest
Instructional placard
Handlebar
Seat bracket
Rear level adjustor
Alignment bracket
Seat plate
Seat frame
Seat bumper