Precor Commercial Stretch Trainer C240 - Manual (Page 7)

page 7
®
c. Align the seat bumper as shown in Diagram 5.
Insert the four bolts and washers through the
seat bumper, seat plate, and into the under-
side of the padded seat. A small space (about
¹⁄₈-inch) will exist between the seat bumper
and the padded seat. To keep the padded
seat aligned properly, alternately finger tighten
each bolt.
d. After making sure that the padded seat is
aligned properly, securely tighten each bolt
with the 6mm hex key.
9. Properly position the knee pad. Diagrams 6
and 7. Align the bolt holes in the knee pad with
the mounting holes in the crossbars.
10. Attach the knee pad to the crossbars.
Diagram 7. Slide a washer onto each of the four
bolts. Then, place a bolt and washer on the end
of the 6mm hex key and insert it through the
crossbars. Thread the bolt into the underside of
the knee pad. To keep the pad properly aligned,
thread all four bolts and then, alternately tighten
each bolt securely.
Note: It is easy to lose a bolt in the crossbars.
To retrieve it, tip the seat assembly on its side
and jiggle it until the bolt drops out of the hole.
11. Install the axle. Diagram 8. Place the seat
frame into position between the seat bracket.
Align the axle mounting hole. Slide the axle
(located in hardware kit) through the bracket
and seat frame. When the axle is halfway
through, stop and place a foot rest on one end
of the axle.
12. Secure the foot rests. Diagram 9. Take an E-
ring (found in the hardware kit) and push it into
position as shown in Diagram 9. Do the same
for the foot rest on the other side. A notch has
been cut into the axle for the E-ring to rest in.
Note: You may need to use a pliers to help
push the E-ring into position.
Diagram 8
Installing the axle.
Seat bracket
Diagram 9
Securing the foot pedals.
Foot rest
Axle
Seat frame
E-ring
Axle
Base rails
Knee pad
Diagram 6
Installing the knee pad.
Padded seat
Crossbars
Seat bumper
Diagram 7
Securing the knee pad.
Crossbars
Bolt and washer
6mm hex key
Place a bolt with
washer on the hex
key before inserting it
through the crossbar.