Panasonic CF-29 Series - Manual (Page 17)

17
Operation
The power saving function is factory set, so if there is no input from a key, the touch pad,
the touchscreen (only for models with touchscreen) or an external mouse (when one is
connected) for a certain interval of time, the power to the LCD and hard disk may be
turned off. The LCD will resume operation when the touch pad, the touchscreen (only
for models with touchscreen) or an external mouse (when one is connected) is used or a
key is pressed.
The power to the LCD may be turned off even when an application software is being
installed. In this case, because it is conceivable that a selection dialog box will be shown,
do not press
Space or Enter to attempt to resume from this condition as doing
so may trigger a selection, but instead, press a key unrelated to the direct triggering of a
selection, like
Ctrl .
In addition, when the computer is left alone, it automatically enters the standby or hiber-
nation mode. The computer will resume by sliding the power switch. (
“Standby/Hibernation Functions”)
NOTE
Three incorrect attempts
or
No password for about a minute
The correct password
Will Start
Enter your password* 1 and press Enter . ( “Security Measures”)
Will Not Start
(Power off)
If [Enter Password] is displayed
* 1 Supervisor Password or User Password set in the Setup Utility (not the Windows password).
Enter Password [ ]